Welcome to Schoolngr.com

Home   School   News   C B T   Classroom
Friday, 22 November 2024

RegisterLogin

(a) In an experiment to measure the specific latent heat of vapourisation of water, a ...

(a) In an experiment to measure the specific latent heat of vapourisation of water, a student places a heater in a beaker containing water. The beaker stands on an electronic balance so that the mass of the beaker and water could be measured. The heater is switched on and readings were taken every 100s when the water starts boiling.

The table below shows the readings.
Time/s 0 100 200 300 400
Reading on balance/g 203.22 201.62 199.79 198.26 196.50
Mass of water evaporated/g 0
Energy supplied by heated/J 0




(I) Fill in the mass of water evaporated.
(ii) Given that the heater supplies energy at the rate of 38J/s, fill in the values of the energy supplied by the heater in 100s, 200s, 300s, and 400s.
(ii) Plot a graph of energy supplied on the vertical axis and mass of water evaporated on the horizontal axis, starting both axes from the origin(0,0).
(iv) Determine the slope of the graph.
(v) what does the value of the slope mean?



STAY UPDATED
FOLLOW US ON :


AboutContact usBack to Top
...

Disclaimer
All Views, Names, Acronyms, Trademarks, Expressed on this website are those of their respective owners. Please note that www.schoolngr.com is not affiliated with any of the institutions featured in this website. It is always recommended to visit an institutions or sources official website for more information. In the same vein, all comments placed here do not represent the opinion of schoolngr.com


SCHOOLNGR - © 2020 - 2024 - Tayo Hammed | Terms Of Service | Copyright | Privacy Policy